Boerne Heater Maintenance & Cedar Season
Tune-ups

Once a year — ideally in October or November, before Boerne’s heating season begins in December. Boerne furnaces sit idle for roughly 7 months while AC handles the Hill Country cooling season. Cedar pollen season (December–February) then immediately stresses filters right at startup. An annual pre-winter tune-up catches idle damage before cedar compounds it.

Honeycomb’s $105–$1,165 heater maintenance visit includes a 21-point inspection: heat exchanger crack check (carbon monoxide risk), burner cleaning, gas pressure verification, ignition system test, blower motor inspection, flue pipe assessment, thermostat calibration, and filter replacement recommendation. For Boerne homes, we factor Kendall County’s cedar and oak pollen load into our filter assessment. Every finding is documented with photos and emailed to you.

Key signs: your heater hasn’t been serviced in over a year; musty or burning smells when the heat kicks on for the first time in fall; uneven heating across rooms; the system short-cycles (turns on and off rapidly); your GVEC bill is higher than expected; or your system is over 10 years old. In Boerne, a system that sat idle through the 7-month AC season is especially vulnerable on its first cold-front startup in December.

A standard Honeycomb heater maintenance visit in Boerne takes approximately 60–90 minutes. The 21-point inspection takes 30–40 minutes, service recommendations and flat-rate quote presentation takes 20–30 minutes, and final system testing takes 15 minutes. If repair work is needed, it is quoted separately and scheduled with your written approval — no work begins without it.

Boerne furnaces face a two-part challenge: 7 months of idle time (April–October) while AC runs, during which dust, corrosion, and igniter degradation accumulate — and then cedar pollen season beginning in December, right when the heater first starts running. This double-stress makes pre-season maintenance more impactful in Boerne than in areas without the cedar factor. Annual maintenance addresses the idle damage before cedar compounds it.

Yes — significantly. A $105–$1,165 maintenance visit prevents the most expensive repairs: cracked heat exchangers can leak carbon monoxide (a serious safety risk), and a dirty furnace burns 10–15% more GVEC gas during Boerne cold fronts. The maintenance typically pays for itself in energy savings within one heating season. Catching a failing igniter or dirty flame sensor during maintenance costs far less than an emergency repair during a December cold snap.

Yes — all three are part of the 21-point inspection. Thermostat: calibration, wiring, and heating-mode settings — especially important for smart thermostats in newer Herff Ranch and Fair Oaks Ranch builds that can lose heating schedules after summer disuse. Burners: cleaned and tested for proper ignition. Airflow: filter condition checked with Kendall County’s cedar and oak pollen load factored into our recommendation.

Yes. A dirty furnace burner burns 10–15% more GVEC gas than a clean one — a measurable increase during December–February cold fronts. Clean heat exchanger surfaces transfer heat more efficiently. A properly calibrated thermostat prevents over-running. Comfy Club members who schedule annual maintenance consistently report lower heating-season GVEC bills compared to years when maintenance was skipped.

Yes. Honeycomb services heat pumps, gas furnaces, and ductless mini-splits — all major brands found in Boerne and Kendall County homes. Aaron Botts and Steven Leon are trained on Amana and Goodman systems (most common in Boerne) as well as older gas furnace configurations found in historic homes near downtown Boerne and Cascade Hills. Same flat-rate pricing regardless of system type. Call (726) 233-6044 to schedule.